CGDI Prog MB can works well with CGDI MB EIS ELV Testing Platform to replace Benz W204 W207 W212 simulator.
Firstly, prepare all the devices as below.
W204 W207 W212 EIS
One original ley
Then follow the corresponding wiring diagram in CGMB software to connect all devices correctly
Next, run CGMB software
Select [EIS-EZS] to read EIS data
Select [Compute Password]-> Copy key with key-> Collect data-> select “Other keys”-> click “OK”
Insert the original key into EIS and click “OK”
Then take out the key and insert into CGDI MB key programmer coil and click “OK”
The key is a BE key, and the key password has been read out
Back to [EIS-EZS], the password will appear in the related textbox, then save EIS data
Select [ELV]-> ELV Simulator-> read simulator
Connect the clip on the OBD yellow line to the K-line on the ELV plug (the finest line among the ELV connecting is the K-line)
Note: If this step has been done before, just make sure the connection is normal.
Then get the simulator password-> load EIS data to get the password-> write simulator
Confirm the connection same as above and click “OK” to continue
Write the ELV successfully
Insert the key into EIS and turn on ignition switch for activation
Read simulator again, now it has been activated successfully
Note: Wipe the ELV simulator will make the simulator in unactivated status.
-Insert a toothpick into ELV simulator until there is a voice appear, then read simulator again, it will turn to unactivated status.
More Mercedes-Benz EIS models and connection diagrams with CGDI MB EIS ELV Testing Platform can be found below.