CG FC200 ECU Programmer with MPC5XX Adapter can perform ECU reading, writing and checksum on AUDI BOSCH MED9.1 no issues. Learn how to connect the device and ECU correctly for available function operations.

Connection Method:
1.Connect FC200 Programmer to a PC via USB cable
2.Run FC200 software with the latest version
3.Navigate to ECU-> Volkswagen (VW)-> BOSCH MED9.1 MPC561/2
4.Check the wiring diagram

5.Connect FC200 Wiring Harness to the Audi MED9.1 ECU properly according to the wiring diagram

6.Connect FC200 MPC5XX Adapter to CG FC200 and default wiring harness

After connection, you can perform ECU read, write, and checksum functions.
Some Related FAQs:
Q1: What about the IMMO function?
A: The immo is in the eeprom file that is about to be ready with FC-200.
Q2: Can it read ecu just with mpc5xx adaptor or that adaptor is for cloning?
A: Read and clone.
Q3: Which power supply is used for fc200? 12v 2amp or 12v 5amp?
A: Use a 12 volt 5 amp supply that plugs into the wall (like a power supply for a computer). But you could use a two amp power supply as well. The ECU doesn’t use much amperage with nothing connected.





