How to Clone Land Rover BCM SPC5746C Module with CG100X?

Cloning a Land Rover Body Control Module (BCM) with an SPC5746C microcontroller using CG100X programmer involves removing, wiring/soldering to the board, reading the original data, and writing it to the replacement module.

Requirement

General Steps for Cloning Land Rover BCM (SPC5746C)

Step 1: Disassemble the BCM

Carefully open the original Land Rover BCM housing to access the circuit board and locate the SPC5746C chip.

Step 2: Weld / Wire Connection

Weld PRO V2 harness from CG100X programmer to the designated test points or chip connections on the BCM board

Step 3: Read Original Data

Connect CG100X to your computer, select the Land Rover BCM SPC5746C option in the CG100X software, and read/save all required data regions from the original module.

Step 4: Write to Replacement Module

Disconnect the original BCM wiring, connect the replacement/donor BCM board to CGDI CG100X, and write the saved data into the replacement module.

Step 5: Verify and Reassemble

Verify that the write process completes successfully, clean up any residual flux or solder points, disconnect the programmer, and install the cloned BCM back into the vehicle for testing.

 

Author: admin