Cloning a Land Rover Body Control Module (BCM) with an SPC5746C microcontroller using CG100X programmer involves removing, wiring/soldering to the board, reading the original data, and writing it to the replacement module.
Requirement
- Original and donor Land Rover BCM SPC5746C modules
- CGDI CG100X Programmer
- CG100X PRO V2 Harness
- 12V Power Supply

General Steps for Cloning Land Rover BCM (SPC5746C)
Step 1: Disassemble the BCM
Carefully open the original Land Rover BCM housing to access the circuit board and locate the SPC5746C chip.

Step 2: Weld / Wire Connection
Weld PRO V2 harness from CG100X programmer to the designated test points or chip connections on the BCM board

Step 3: Read Original Data
Connect CG100X to your computer, select the Land Rover BCM SPC5746C option in the CG100X software, and read/save all required data regions from the original module.

Step 4: Write to Replacement Module
Disconnect the original BCM wiring, connect the replacement/donor BCM board to CGDI CG100X, and write the saved data into the replacement module.

Step 5: Verify and Reassemble
Verify that the write process completes successfully, clean up any residual flux or solder points, disconnect the programmer, and install the cloned BCM back into the vehicle for testing.





