This is my CG FC200 programmer. I bought at cgdishop.com and just got it delivered via dhl from China. I bought FC200 full version with new adapters set, so it comes with 2 plastic boxes. I can see FC200 programmer, usb cable, more wires, plugs and adapters inside.

I have a 2016 BMW 328I F30 N26, all keys are lost. So I used this cg fc200 to read isn and program new key by yanhua acdp.

It makes my work so much easier. Just took minutes to read the ISN.

Here is the whole process I tested.

Follow the wiring diagram in the CG FC200 software to connect all devices

Double click the wiring diagram to zoom in

You can move it around and make it larger

Connect FC200 and the corresponding ECU, and connect to the laptop

Plug in the FC200 DC12V interface with 12V power supply

Select BMW, 3 series (F30), bosch mevd17.2.9 TC1797, 328i N26B20C0 245

First, do the identification

It read out the chip, serial number and hardware ID successfully.

Then go to read ISN

It read out the ISN fast and I was able to make the key for my bmw. It was done in minutes.

I was using an acdp to program the key and it literally just took minutes. It didn’t even take a long time.

Okay! That’s my experience of using CG FC200.

Have fun!