Have one CG FC200. Use it to read password and backup data on Fiat Doblo EDC17C49 via bench mode successfully.

This is Doblo BOSCH ECU.

I have connected cg fc200 ecu programmer with the Doblo EDC17C49 ECU and computer.

Then open CG FC200 software to operate.

Select the car info as below.

Car brand: Fiat

Car model: Doblo (263)

ECU: BOSCH EDC17C49 TC1797

Engine-gearbox: 1600 Multijet 198 A3.000 105

First click ‘Identification’ to identify the ECU successfully

Then read DFlash and PFlash in sequence, and backup the dada read out

Back to the main menu

Select Boot and read password

Choose the type MED17/EDC17 GPT

Got the prompt “Ready to read the password, please check whether the current connection mode is PASSWORD READING, and confirm. Please select ‘Yes’. (Note: If there are resistors or wires connected in BOOT mode on the PCB, please disconnect them all first).”

Wait a moment to read the password.

Good job! Read out the password and save it.